Oh man, the dreaded head hose clog! but, IP customer service is right, it's tricky, but totally manageable.I need to remove the hoses running from the head to the overboard sea cock through the anti-siphon loop because they're clogged. I talked to IP customer service, they said it's tricky and gave me some tips. Has anyone actually taken these hoses out?
Cutting them out sounds like a last resort, but I'll keep a heat gun handy just in case, any tips on loosening those clamps without damaging the fittings?Doable, but can be a tight and messy job. The hoses are often stiff and cramped in place, especially around the anti-siphon loop. Some owners reporrted they had to cut the old hoses out and replace them entirely. Having a heat gun, some patience and good access helps a bunch. Take time and be ready for a bit of a struggle.
Thanks for the encouragement, that twist-and-split tip sounds super useful. How long did it usually take you to get through a full hose replacement? I am just trying to set my expectationsOh man, the dreaded head hose clog! but, IP customer service is right, it's tricky, but totally manageable.
so, the hardest part is usually getting leverage in tight spots, especially at the anti-siphon loop's high point. Cut the hose strategically if you have to, especially if you're replacing the whole run. Twist the hose aggressively at the barb, sometimes even splitting the end with a utility knife (carefully!) if it's really seized.
Be prepared for the smell, ventilation, and plenty of disposal bags! You got this!
I've heard that using a combination of penetrating lubricant and a small pry tool, like a plastic trim remover, can help loosen the hoses without damaging anything, has anyone tried that?Have you found any tools or techniques that make removing those hoses easier without damaging the fittings or the anti-siphon loop?